Detailed Product Information
Fasteners offer a practical and reliable solution to fitting
a cloth nappy, without using nappy pins. It is made
from a stretchable non-toxic material, which is T-shaped
with grips on each end. These grips hook into the
cloth nappy to ensure a snug but comfortable fit for baby
making using environmentally friendly cloth nappies easy and
ouch less! (for you and baby).
• Recomend the
use of two or three Snappi® Nappy Fasteners in rotation
• Snappi® can be used with flat or pre-fold cloth nappies,
and works best on towelling nappies.
• One size fits all
The Snappi fastener underwent a makeover in 2006. The basic
shape & function remains the same, the only change being
that the rings at the end of each leg have been replaced
with a solid piece embossed with the Snappi logo & a
crescent-shaped loop at the end of each leg, which gives the
Snappi this extra safety feature.
Snappi fastener is not in use, fold the loop over the back
of the Snappi end to fit over the teeth of the white grip -
see photo below. This acts as a barrier & prevents the sharp
teeth from being exposed. These loops are NOT to be pulled
on when attaching the Snappi fastener to the nappies. When
attaching the Snappi, hold onto the solid part of the tab.
Keep all Snappi fasteners out of childrens reach when not in
Snappi fasteners must be used responsibly, & need to be used
correctly in order to work effectively.
1. STRETCH the Snappi fastener before its first use.
The stretching triggers the 'memory' of the Snappi to return
to its original size & in so doing, pulls the nappy together
to the middle to allow for a snug fit. This is essential
for the Snappi to work properly. This can be done by
holding the Snappi in the centre with one hand & close to
the end of the leg with the other hand. Then s-t-r-e-t-c-h
a few times (10 or so). As you do this you should feel how
the material 'softens' or gets more elastic. Follow this
stretching procedure with each leg. The Snappi is now ready
2. Make sure that the Snappi is ATTACHED SECURELY. It
is important that the Snappi 'leg' being attached be
stretched across the nappy before hooking it into the nappy.
When attaching the Snappi, hold onto the solid part of the
tab. DO NOT pull on the loops.
Stretch ACROSS & Hook Right
Stretch DOWN & Hook Center
The Snappi fastener should go from a T shape to a Y shape.
By following these instructions, the Snappi should be secure
& the nappy will fit snugly. always place a cover over the
nappy & Snappi fastener.
How It Works